I also removed my reverse motor cover as it got damaged going over a speed bump on my parents drive. The cover did its job as the motor was not damaged. For now I will straighten with a hammer and look to make one from steel after the IVA.
Sunday 1 September 2013
Retro-reflectors = reverse motor cover
Not much left to do on the car now so today I installed the rear reflectors. The type I bought have a hole in the centre so I fixed them below the rear light clusters with an M5 bolt, ensuring they were minimum 250mm form the floor and maximum 400mm from edge of vehicle.
I also removed my reverse motor cover as it got damaged going over a speed bump on my parents drive. The cover did its job as the motor was not damaged. For now I will straighten with a hammer and look to make one from steel after the IVA.
I also removed my reverse motor cover as it got damaged going over a speed bump on my parents drive. The cover did its job as the motor was not damaged. For now I will straighten with a hammer and look to make one from steel after the IVA.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment