Tonight I had
a go at making a new gearshift bracket out of some 2” hollow square
section. I cut and welded the bits
together but overall I am not happy with how the piece looks. I plan to remake this from a single piece of
3mm plate so it looks neater.
Also
started on the gear indicator. I marked
the hole in the dash above the steering wheel with the position checked by
sitting in the car and ensuring it could be seen in a normal seated
position. I cut and bend small lengths
of 1.2mm aluminium to make a bracket to hold the gear indicator module. The plan is to mount this in a similar way to
the clocks so that no fixings can be seen.
Sitting in the car to check the gear indicator can be seen
No comments:
Post a Comment