The foglight I bought is E marked and also F marked, a requirement for IVA. Its also a requirement for the light to be vertical when mounted. I made a mounting bracket by bending a piece of 30mm aluminum strip around the outside of the foglight and then cutting it to the same angle as the rear panel of the car, about 15 degrees. I then carbon wrapped both the bracket and light surround.
Next job was to start on the bonnet catches. I bought the rubber IVA OK type from CBS. The are fitted with 4no 4mm rivets per catch. I marked and drilled 100mm from the edge of the bonnet. The first one I fitted could have been tighter so I will drill the holes further apart on the others.
Holes marked for bonnet catch
No comments:
Post a Comment