After looking at MKs latest track day car I
could see where the best position for the loom would be; this is between the
engine and the cradle. I also found the
best positions for the starter relay, ECU and rectifier so I made some brackets
from aluminium.
Bracket for ECU
ECU in position
Rectifier bracket
Brackets mounted to chassis
I also installed the clutch cable. To do this was simple using the MK supplied kit but I am not keen on the grub screws in the clevis and nipple along holding the force of the clutch. I plan to redo this when I shorten the cable and loop each end back on its self and secure with a 3mm wire clamp.
Plastic top hat tapped to M6 - this fits into the tube through bulkhead for clutch cable
Put in drill to sand down - slightly too big to fit in the tube
No comments:
Post a Comment